Skip to main content
AmigoFish

What’s Keeping This Garage Floor From Collapsing?

From HAUS PLANS ®️ · · 59 sec

The player loads from YouTube only when you click. It uses YouTube's privacy-enhanced mode.

If the video does not play, the owner may have turned off embedding. Watch it on YouTube instead.

Watch on YouTube

Not rated yet

Description

What will keep this garage floor from collapsing under the weight of a vehicle? Grade Beams. A grade beam is a reinforced concrete beam that sits under a slab. These beams will be supported by a pier in the middle and pockets in the foundation walls. The engineering for this slab calls for 3 half inch rebars in each beam. The building code in our area requires an engineered design for any garage with more than two feet of fill. Now a lot of people think rusty rebar is a problem, but it’s not. Once the rebar is fully encased in concrete it can no longer get oxygen and the rusting process stops. This floor will be a suspended slab. In theory, after the concrete cures you could actually dig out all the gravel and the floor would be fine. Here you can see where both grade beams pass over the pier in the middle. The floor engineering calls for a 4” thick slab with a ½” rebar grid 12” on center both ways. The entire floor is supported by the foundation walls and grade beams with a pier in the middle. So, what do you think? Did we use too much rebar or not enough? @hausplans

#build #howto #construction #diy #contractor #concrete #garage

Back to HAUS PLANS ®️ · Report a problem