Skip to main content
AmigoFish

How to Patch a Hole in Subfloor

From HAUS PLANS ®️ · · 59 sec

The player loads from YouTube only when you click. It uses YouTube's privacy-enhanced mode.

If the video does not play, the owner may have turned off embedding. Watch it on YouTube instead.

Watch on YouTube

Not rated yet

Description

This is not gonna work- A floor register got installed right by the front door. Let’s see if we can move it… The boots for these registers are held in with roofing nails. So, I use a cat’s paw and a hammer to pry on the boot and then I pop the nails out. Luckily, the flex line wasn’t hooked up yet. I asked The New Guy if he could work late and patch this hole, he mumbled something about dinner plans and drove off. I guess I’ll do it myself. I start by cutting a piece of subfloor 2 inches bigger than the hole all the way around. Then I install a 3” screw in the middle to use as a handle. Next, I put subfloor adhesive around the edges. I lower it the piece down through the floor using the screw as a handle and pull it back up tight. I use the claw end of my hammer to hold the board tight while I fasten it in place with screws. If you ask me, glue is like horsepower- you can’t have too much. I found the piece of subfloor that was cut out for the floor register and put it right back in the hole. I’m screwing it down with 1 ½” T25 deck screws. Honestly, I would argue that this repair is stronger than the original floor- what do you think? @hausplans

#build #howto #construction #diy #contractor #hack

Back to HAUS PLANS ®️ · Report a problem