How to Strip Concrete Forms Like a Pro
From HAUS PLANS ®️ · · 1 min

The player loads from YouTube only when you click. It uses YouTube's privacy-enhanced mode.
If the video does not play, the owner may have turned off embedding. Watch it on YouTube instead.
Description
It’s been less than 24 hours since we poured this garage floor- now it’s time to strip off the forms. I’m going to show you how strip forms like a pro. Every now and then there’s a T25 screw that stays in the board- just turn the board upside down, give it a few taps with the hammer and it’ll back right out. I used Tapcons to attach these 2x10s to the foundation, but sometimes you’ll get one that’s stripped. I like to take the bit out of the driver, line it up with the head, and give it a few taps with the hammer; then I reconnect the driver. Now it will back right out. This happens because they were sunk too deep or the wood swelled up. Often when you first remove the forms, you’ll have sharp edges. I take my hammer and scrape the edge, this will clean it up. When a form board’s really tight- I tap it gently with my hammer. This loosens it up. Also never pry against the concrete when it’s green- you could easily take out a chunk. Call me cheap, but these days I’m saving the screws. I might not use them for something permanent, but they’re great for form work. These boards on the other hand are headed to the dumpster. @hausplans
#build #howto #construction #diy #contractor