Lumber’s Not Getting Any Straighter- Here’s a Fix
From HAUS PLANS ®️ · · 1 min

The player loads from YouTube only when you click. It uses YouTube's privacy-enhanced mode.
If the video does not play, the owner may have turned off embedding. Watch it on YouTube instead.
Description
I don’t know if you’ve noticed but lumber’s not getting any straighter Here’s how to fix a crooked stud without replacing it using a scrap piece of wood and deck screws. First, I cut a 1 ½” by 3 ½” notch in the crooked stud. I set the depth on my circular saw and cut the bottom and top. Then I use my multi-tool for the vertical cut- I make sure to keep the blade moving. Now you’re probably asking- why did you use a crooked stud? We pick through and use straight studs to start with, but there’s always a few that go crooked as they dry out. Next, I put my scrap piece of wood into the notch that I cut and attach it to the stud on either side - I use two deck screws in each stud. Now this is a non-load bearing wall, so it’s ok to notch out an inch and a half. I mark the center on the scrap wood and start two screws; then I pull the crooked stud into place. Here’s the cool part- watch how the screw pulls the stud forward. Now, this stud is plumb right to left and in and out. Let me know if you think this is the smartest thing you’ve ever seen. @hausplans #build #howto #construction #contractor #hack