Skip to main content
AmigoFish

Forming the World’s Strongest Concrete Step

From HAUS PLANS ®️ · · 58 sec

The player loads from YouTube only when you click. It uses YouTube's privacy-enhanced mode.

If the video does not play, the owner may have turned off embedding. Watch it on YouTube instead.

Watch on YouTube

Not rated yet

Description

I’m building the world’s strongest step. To start with I drilled and epoxied a ½” rebar grid into the foundation; then, I installed this massive piece of 1” rebar in the bottom. Next, I needed to form up for concrete. I’m using ¾” plywood. I reinforce the corner of the form with 2 by material. I make sure to place them on the outside of the form, so they don’t interfere with the concrete. Then, I cut a piece of 2x6 to reinforce the front of the form. I install it flatways near the top with T25 screws. This will keep the form from bulging out under the weight of the concrete. I fasten the form to the foundation using ¼’ masonry screws. First, I drill a pilot hole- I’m using a 3/16” SDS bit. The threads on the screw are slightly bigger than the pilot hole, so they cut into the concrete as they go in. Concrete is heavy so I fasten some blocks to the wing walls at the bottom of the form so it can’t push out. Finally, I cut wedges to adjust the height of the form. I want the step to have a ¼” of slope away from the house. @hausplans

#build #howto #construction #diy #contractor #concrete

Back to HAUS PLANS ®️ · Report a problem