Skip to main content
AmigoFish

A Look Into Putting a CR125 Engine Into a CRF150RB Chassis

From Carson Brown MX · · 47 sec

The player loads from YouTube only when you click. It uses YouTube's privacy-enhanced mode.

If the video does not play, the owner may have turned off embedding. Watch it on YouTube instead.

Watch on YouTube

Not rated yet

Description

Over on YouTube we talk over the whole build about putting a CR125 engine into a CRF150RB. The frame and swingarm was cut up to get modern geometry. I saw a few people asking how much bigger this makes the bike. It ends up about the same size as the old KTM 105SX. The 150RB in stock form starts out a bit smaller compared to a lot of the supermini’s. To go along with putting the CR125 engine in and the frame mods, it has a fully hand made custom air box to keep maximum air volume for the 125 air boot and filter. A hand made aluminum gas tank that will make a 30 minute moto. A custom pipe to make sure it didn’t loose any power. Massive thanks to BBR Motorsports and Duane Brown for making this happen from the ground up. I wasn’t able to be there for most of it so this is mostly video that he texted along the way while doing it! We appreciate Red Bull USA for supporting the build along with Honda Powersports, MotoSport.com and All Balls Racing. Dubya did the wheels, Dunlop tires,Bud Racing triple clamps, Renthal bars, grips and chain, Backyard Design graphics with a Guts Racing seat, Bolt Motorcycle Hardware Bolts and washers, Hinson with the clutch, a Lectron Fuel Systems Billetron, Maxima Racing Oils fluids, and everyone else who made this happen. #CR125 #CRF150R #honda

Back to Carson Brown MX · Report a problem